HOMMEL-ETAMIC Opticline C300

Producer:

JENOPTIK Industrial Metrology Germany

This series of equipment offers a wide range of production solutions and includes three models of compact devices: Opticline C305, C310 and C314. They are suitable for measuring various objects: from the engine valves to the turbocharger shafts and short transmission shafts.

Using a system of high-resolution cameras it is easy to measure very small geometric elements of hardened shafts, obtained by turning. You can measure
parts with a total length of up to 300 mm, diameter from 0.2 mm to 140 mm and weight up to 10 kg.

System benefits:

Full measurement in a few seconds;
High resolution and accuracy;
Low operating costs and virtually no wear;
Automatic measurement operation;
Enclosed housing with doors, optionally with motorized opening / closing drive;
Intuitive and simple TURBO OPTIC software.

Specifications:

Model	С305	С310	С314
Limits of measurement
Diameter, mm:	0,2 – 50	6 – 100	0,2 – 140
Length*, mm:	300	300	250
Dimensions
Diameter, mm:	150		150
Length*, mm:	300		280
Gravity, N:	100		100
Resolution
Diameter, mkm:	0,1
Length, mkm:	0,1
Rotation, °:	0,018
Accuracy / MPE **
Diameter, mkm:	2 + D [мм] / 100
Length, mkm:	5 + L [мм] / 100
Repeatable ***
Diameter, mkm:	0,5
Length, mkm:	3
Speed
Measuring, mm/s:	Automatically optimized measurements: 10 – 80
Measuring rotation, r/s:	1
Positioning, mm/s:	200
Positional rotation, r/s:	1
Measurement time:	Depends on the type and number of test characteristics usually 3 … 30 s
Dimensions of the measuring system [WxDxH], mm	780 × 650 × 912
Mass of the measuring system, N:	1 400	1 450	1 550
Interfaces of clamping devices
The lower Morse center:	МК 2
The Morse cone:	МК 2
Upper Center:	Manual, 20 mm
Source of power
Connection			AC-PH, N, PE
Voltage, V:	230 / 115
Frequency of mains, Hz:	50 / 60
Power consumption, kVA:	1,5

* – Between the tips of the standard supply set. The length can be reduced depending on the clips.
** – Surface of polished part, ambient and object temperature 20°C ± 1°C.
Changes in ambient temperature of less than 0.5°C/h, in accordance with DIN EN ISO 10360 or VDI / VDE 2617.
Mechanical environmental conditions according to DIN EN 30721-3-3, class 3M2.
*** – With 25-times measurements on the surface of polished parts (according to VIM).

Examples of using the Opticline C300 system:

Measurement of injection components;
Measuring the valve piston;
Measuring the injector needle;
Measurement of turbocharger shaft;
Measure motor valve with flexible, pneumatic clamp.

Accessories and clamping devices:

There is a wide choice of clamping devices, which guarantees reliable fastening of the shafts. Flexible holders MK 2 (with a cone of Morse 2) allow you to adapt the system to measure different objects.

Below are the most commonly used fasteners and clamping chucks: