The non-contact principle of operation and the separate design of the two parts eliminate the need to use the bearing and provide high reliability and simple installation.

The sensor consists of a magnetic actuator and, separately, the sensor housing. The rotation of the magnetic actuator detects a microcircuit placed inside the casing and converts changes in the magnetic field gradient into an output signal of a certain format.

The received signals are interpolated and at the output of the sensor itself have a bit capacity of up to 13 bits (8192 signals/rev), with an operating speed of rotation of the actuator up to 30,000 rpm. The output signals are compatible with all industry standards and have an incremental or analog formats.The diameter of the hermetic housing is 36,5 mm has a degree of protection – IP68. RM36 can be used in a variety of devices.

Specifications:

• Diameter, mm: 36,5
• Sensor weight with 1m cable (without connector), g: 85
• Weight of magnetic actuator, g: 12
• Length with magnetic actuator, mm: 33
• Housing design: non-contact
• Resolution, bit: up to 13 (8192 signals/rev)
• Output formats: incremental and analog (compatible with industry standards)
• Maximum rotation speed, rpm: up to 30,000
• Maximum error: ± 0.5 °
• Supply voltage, V: 5 and 24
• Degree of protection: IP64, IP68
• Cable output: radial
• Diameter of the attached drive shaft, mm: 4, 5, 6, 8, 10
• Connector types: without connector, 9-pin or 15-pin “D” connector (parallel format only)
• Operating temperature, ° C: -40 to +125 (depends on the type of output)
• Sensor body material: aluminum.
• Actuator material: stainless steel